| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE KEY TO TURN THE MACHINE OFF AND PULL THE CHARGER PLUG TO DISCONNECT THE BATTERIES. PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 2 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE.
| Wrench-Allen metric 6.0mm |
|
|
| 4 |
|
LIFT THE TANK TO OPEN THE MACHINE AND DISCONNECT THE BATTERY CABLES AND REMOVE THE 2 BATTERIES.
| Wrench-metric 10mm |
|
| Wrench-metric 13mm |
|
|
| 5 |
|
REMOVE THE 2 BOLTS HOLDING THE BRUSH SHROUD
| Wrench-Allen metric 6.0mm |
|
|
| 6 |
|
LAY THE MACHINE ON ITS SIDE.
|
| 7 |
|
REMOVE THE 3 SCREWS FROM THE COVER
| Wrench-Allen metric 6.0mm |
|
|
| 8 |
|
PULL TO REMOVE THE COVER
|
| 9 |
|
TURN THE BRUSH PULLEY TO CHECK FOR LOCKED UP CONDITION. IF THE BRUSH PULLEY TURNS FREELY, IT IS NOT LOCKED UP.
|
| 10 |
|
IF THE BRUSH PULLEY IS OKAY, REVERSE STEPS 7 THRU 9 TO REASSEMBLE THE MACHINE. RECONNECT THE CHARGER PLUG. RECONNECT THE BATTERY CABLES USING THE DIAGRAM SHOWN HERE.
|